Orchard Safety: Communicating With Hand Signals

Noise is a major hazard affecting farm workers, as it impacts their ability to communicate with equipment operators. Often this noise and the distance needed for a worker to safely be seen by equipment operators can limit the ability to verbally communicate. Some equipment tasks require a helper to assist with connecting implements or loading supplies. An increased risk for equipment runovers as well as crushing can occur.

Standard Hand Signals

Below are photos of some standard hand signals adopted by the American Society of Agricultural and Biological Engineers (ASABE) to communicate machine operations.

ASABE Hand Signal 1: This Far to Go

Place palms at ear level facing head and move inward to show remaining distance to go.

ASABE Hand Signal 2: Come to Me

Raise the arm vertically overhead, palm to the front, and rotate in large horizontal circles.

ASABE Hand Signal 3: Move toward Me—Follow Me

Point toward person(s), vehicle(s), or unit(s). Signal by holding arm horizontally to the front, forearm and palm up, and motioning toward the body.

ASABE Hand Signal 4: Move Out—Take Off

Face the desired direction of movement; hold the arm extended to the rear; then swing the arm overhead and forward in the direction of desired movement until the arm is horizontal with palm down.

ASABE Hand Signal 5: Stop

Raise the hand upward to the full extent of the arm, palm to the front. Hold that position until the signal is understood.

ASABE Hand Signal 6: Speed It Up—Increase Speed

Raise the hand to the shoulder, fist closed; thrust the fist upward to the full extent of the arm and back to the shoulder rapidly several times.

ASABE Hand Signal 7: Slow Down— Decrease Speed

Extend arm horizontally sideward with palm down; wave arm downward at 45 degrees minimum several times. Do not move arm above horizontal.

ASABE Hand Signal 8: Start the Engine

Move arm in circular motion at waist level to simulate cranking engine.

ASABE Hand Signal 9: Stop the Engine

Draw right hand, palm down, across the neck in a motion left to right.

ASABE Hand Signal 10: Lower Equipment

Use circular motion with either hand pointing to the ground.

ASABE Hand Signal 11: Raise the Equipment

Make circular motion with either hand at head level.

It is important to learn all 11 standard hand signals. Use them and teach them to all other workers at the farm including the farm owners.

Developed for Penn State Extension Bilingual Tractor Safety Trainings for Specialty Crop Growers, with support from Specialty Crop Block Grant #ME44187248.

Additional Resource

Use of hand signals in production agriculture. (2012) Farm and Ranch eXtension in Safety and Health (FReSH) Community of Practice.

References

Hazardous Occupation Safety Training in Agriculture (HOSTA) National Safe Tractor and Machinery Operation Program, The Pennsylvania State University 2013.

American Society of Agricultural and Biological Engineers, ANSI/ASAE S351, Hand Signals for Use in Agriculture, St. Joseph, MI.

Reviewed by Linda Fetzer, Penn State Extension Associate, Agricultural Safety and Health